Ultra Clear RO EDI 30 Reverse osmosis/ EDI combination Pure Water System

Ultra Clear RO EDI 30 Reverse osmosis/ EDI combination Pure water production from softened potable tap water. The system combines the technology of the reverse osmosis with the final deionization of the permeate by single bed electroeioni- zation. The system is placed in a well-designed plastic housing. The reverse osmosis component mainly consists of: 1 Solenoid valve for raw water 1 Pre-treatment module AMD, fine filter made of plastic, inclusive active carbon/fine filter cartridge 5 µm, front-side operated 1 Pressure switch as pump protection 1 High pressure pump made of brass with magnetic-coupled E-motor 1 Pressure gauge to indicate operating pressure 1 Module set with spiral-wound membranes, made of polyamide on a polysulphone basis, incl. pressure vessel with end caps 1 Solenoid valve for permeate reject when conductivity is exceeded 1 Conductivity meter for permeate 1 Restrictor for limiting the concentrate quantity The Ionpure component mainly consists of: 1 Ionpure cell, two-pass, with chambers for anion and cation exchange resin and brine chambers, anodes, cathodes, ion-selective membranes and end plates 1 Conductivity meter for pure water 1 Restrictor for limiting the brine 1 Conditioning cartridge Control: Display with membrane keyboard with monitor for: - Conductivity permeate and pure water - Level indication storage tank in Percent for level sensors or fixed value for float switches - 3 free selectable switching activating points ON/OFF and running dry-protection for booster pump - Status indication via symbols - Indications for maintenance intervals and replacement of cartridge - Fault indication (insufficient raw water, insufficient permeate, conductance LF1 / LF 2) - Timer program for displacement of concentrate and module flushing - RS 232 interface (processing software optional) - Multilingualism 1 set connecting hoses 1 filter cup wrench 1 operator's manual Performance specifications: - Production rate at 15°C: 30 l/h - Conductivity: < 0.2 µS/cm - typical conductivity: 0.07 µS/cm - Silicate content: < 10 ppb - TOC value: < 30 ppb - particle rejection: > 99 % Feed water specifications: - Flow rate: 44 - 66 l/h - Pressure: 0,1 - 5 bar - Maximum conductivity: < 1400 µS/cm - SDI: < 3 - FE and free chlorine: < 0,1 mg/l - CO2 value in the feed: < 10 mg/l - max. SiO2 value in the feed: < 10 mg/l - Permissible water temp.: 5 - 30°C Technical data: - Operating pressure: max. 6 bar - Electrical power: 100-240V, 50-60 Hz - Current consumption: 0.2 kW - Fuse: 16 A - Permissible ambient temp.: 5 - 35°C Connections: Raw water: 3/4" Pure water: d= 8 mm Drain concentrate: d= 8 mm Drain brine: d= 6 mm Dimensions and Weight: Height: 530 mm Width: 340 mm Depth: 420 mm Weight: 35 kg Please note: The performance is based on a raw water salt content of max. 750 mg/l (TDS) equivalent to a conductivity of 1400 µS/cm at 15°C. From 10°dH or higher, a softener is recommended. All a. m. components are assembled into a complete system. The Ultra Clear RO EDI can be put into operation without the help of a factory service engineer. The feed water specifications are guidelines. The pure water specifications can only be guaranteed, if a drinking water analysis is available for the plant location and all other relevant parameters have been evaluated. more